 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| LED Large Lamp LT9600CU LT9600CU s Outline Dimensions 6.8 2.39 2.39 NOM NOM 6.8 ! 7.6mm, Oval Type(Flangeless), Colorless Transparency, High-luminosity, Wide Viewing Angle, Dichromatic Large LED Lamp for Outdoor Use (Unit : mm) s Radiation Diagram -30 -20 -10 0 100 +10 +20 +30 (Ta=25C) Relative luminous intensity(%) Colorless transparency Protruded resin 1.5MAX Sunken resin1.0MAX 7.6 -40 Yellow-green 80 Red +40 -50 +50 60 13.20.5 9.8 -60 +60 40 +70 20 +80 1.0MAX 1.0 -70 Tie-bar cut 1.4 (0.4) 3-0.5 1.1 20.0MIN (1.0) -80 -90 (Long diameter) +90 0 (2.0) (2.0) (Short diameter) -30 -40 -20 -10 0 100 +10 +20 +30 +40 Above the tie-bar0.5 +0.3 - 0.1 Relative luminous intensity(%) Below the tie-bar0.5 2.54 2.54 NOM NOM -50 0.2 Yellow-green 80 Red +50 60 1 2 3 Pin connections 1 Cathode(Yellow-green) 2 Anode(Common) 3 Cathode(Red) Unspecified tolerance:0.2 -60 +60 40 +70 20 -70 -80 +80 -90 0 +90 s Absolute Maximum Ratings Model No. Radiation color Radiation material Power dissipation Forward current Peak forward current P*1 IF IFM*2 (mW) (mA) (mA) (Ta=25C) Derating factor Reverse voltage Operating temperature Storage temperature Soldering temperature (mA/C) VR Topr Tstg Tsol*3 (V) (C) (C) (C) DC Pulse 260 84 30 100 0.40 1.34 5 Yellow-green GaP -30 to +85 -30 to +100 75 30 50 0.40 0.67 4 Red(Super-luminosity) GaAlAs on GaAlAs *1 The value is specified under the condition that either color is lightened separately. When the both diodes are lightened simultaneously, the power dissipation of each diode should be less than the half of the value specified in this table. *2 Duty ratio=1/10, Pulse width=0.1ms *3 5s or less(At the position of 1.6mm or more from the bottom face of resin package) LT9600CU s Electro-optical Characteristics Radiation Lens Model No. color type Colorless Yellow-green transparency LT9600CU Red Forward voltage VF(V) TYP 2.1 1.85 MAX 2.8 2.5 Peak emission wavelength IF p(nm) (mA) TYP 565 20 660 20 Luminous intensity IF IV(mcd) (mA) TYP 100 20 300 20 Spectrum radiation bandwidth IF (nm) (mA) TYP 30 20 20 20 Reverse current VR IR(A) (V) MAX 10 4 100 3 Terminal capacitance Ct(pF) TYP 35 25 (Ta=25C) Page for characteristics (MHZ) diagrams 1 1 In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device. (Internet) Data for sharp's optoelectronic/power device is provided for internet.(Address http://www.sharp.co.jp/ecg/) (Notice) 85 EG series Forward Current Derating Curve 60 Forward Current vs. Forward Voltage(Note) 100 50 (Ta=25C) Luminous Intensity vs. Ambient Temperature(Note) 1000 500 (Ta=25C) 50 Relative luminous intensity(%) 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 Forward current IF(mA) Forward current IF(mA) 40 10 5.0 100 50 30 20 1.0 0.5 10 5.0 10 0 -25 0 25 50 75 85 100 125 0.1 1.0 1.0 -20 0 20 40 60 80 100 120 Forward voltage VF(V) Ambient temperature Ta(C) Ambient temperature Ta(C) Peak Forward Current Derating Curve 60 Luminous Intensity vs. Forward Current(Note) 1000 500 (Ta=25C) Duty Ratio vs. Peak Forward Current (Ta=25C) 500 200 Peak forward current IFM(mA) 100 50 50 Relative luminous intensity(%) 200 100 50 Peak forward current IFM(mA) 40 30 20 10 5.0 2.0 20 10 5.0 2.0 1.0 20 10 0 -25 0 25 50 75 85 100 125 1.0 0.1 0.2 0.5 1 2 5 10 20 50 1/50 1/20 1/10 1/5 1/2 1 Ambient temperature Ta(C) Forward current IF(mA) Duty ratio DR Note)Characteristics shown in diagrams are typical values. (not assurance value) UR series Forward Current Derating Curve 60 Forward Current vs. Forward Voltage(Note) 100 50 (Ta=25C) Luminous Intensity vs. Ambient Temperature(Note) 1000 500 (Ta=25C) 50 Relative luminous intensity(%) 1.2 1.4 1.6 1.8 2.0 2.2 2.4 2.6 Forward current IF(mA) Forward current IF(mA) 40 10 5.0 100 50 30 20 1.0 0.5 10 5.0 10 0 -25 0 25 50 75 85 100 125 0.1 1.0 1.0 -20 0 20 40 60 80 100 120 Forward voltage VF(V) Ambient temperature Ta(C) Ambient temperature Ta(C) Peak Forward Current Derating Curve 60 Luminous Intensity vs. Forward Current(Note) 1000 500 (Ta=25C) Duty Ratio vs. Peak Forward Current (Ta=25C) 500 200 Peak forward current IFM(mA) 100 50 50 Relative luminous intensity(%) 200 100 50 Peak forward current IFM(mA) 40 30 20 10 5.0 2.0 20 10 5.0 2.0 1.0 20 10 0 -25 0 25 50 75 85 100 125 1.0 0.1 0.2 0.5 1 2 5 10 20 50 1/50 1/20 1/10 1/5 1/2 1 Ambient temperature Ta(C) Forward current IF(mA) Duty ratio DR Note)Characteristics shown in diagrams are typical values. (not assurance value) |
Price & Availability of LT9600CU
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |